Comtrol AT Commands - Manual (Page 161)

AT Commands for CX81801/CX06833/CX81300/CX06827 Modems Reference Manual
102184B Conexant 4-7
+FAE - Auto Answer Enable
This command enables or disables fax adaptive answer. This command operates
identically to the +FAA command.
Syntax
+FAE=<value>
Defined Values
<value> Decimal number corresponding to the selected option.
0 Disable data /fax auto answer mode. (Default.)
1 Enable data /fax auto answer mode. The modem
determines the calling type and issues DATA
result code (13) if the caller is a data modem or
issues FAX result code (15) if the caller is a fax
modem.
After a data (not fax) connection is achieved (indicated by the DATA result code), the
DTE must issue an ATO command to cause the modem to go on-line.
+FTS - Transmit Silence
This command causes the modem to terminate a transmission and wait for <time> 10-ms
intervals before responding with the OK result code.
Syntax
+FTS=<time>
Defined Values
<time> Decimal number from 0 (default) to 255 which specifies the
length of time in 10-ms intervals to delay before responding
with the OK result code after terminating the session.
Result Codes
OK Reported when transmission has been terminated for the
specified amount of time.
ERROR <value> is invalid or this command is issued while the modem
is on-hook.
Reporting Supported Range of Parameter Values
Command: +FTS=?
Response: +FTS: <time> range
Example: +FTS: 0-255