Comtrol AT Commands - Manual (Page 98)

AT Commands for CX81801/CX06833/CX81300/CX06827 Modems Reference Manual
Conexant 102184B
3-72
The third case is where a break is received from a remote
modem during a non-error corrected connection:
0 Clears data buffers and sends break to the DTE.
1 Clears data buffers and sends break to the DTE.
(Same as 0.)
2 Send a break immediately to DTE.
3 Send a break immediately to DTE. (Same as 2.)
4 Send a break in sequence with received data to
DTE.
5 Send a break in sequence with received data to
DTE. (Same as 4.) (Default.)
Result Codes
OK 0 to 5.
ERROR Otherwise.
-K - MNP Extended Services
Enables or disables conversion of a V.42 LAPM connection to an MNP 10 connection.
The parameter value, if valid, is written to S40 bits 0 and 1.
Syntax
-K<value>
Defined Values
<value> Decimal number corresponding to the selected option.
0 Disables V.42 LAPM to MNP 10 conversion.
(Default.)
1 Enables V.42 LAPM to MNP 10 conversion.
2 Enables V.42 LAPM to MNP 10 conversion;
inhibits MNP Extended Services initiation
during V.42 LAPM answer mode detection
phase.
Result Codes
OK 0 or 2.
ERROR Otherwise.