Comtrol AT Commands - Manual (Page 73)

AT Commands for CX81801/CX06833/CX81300/CX06827 Modems Reference Manual
102184B Conexant 3-47
\V - Single Line Connect Message Enable
This command enables or disables the single line connect message format as follows:
Syntax
\V<value>
Defined Values
<value> Decimal number corresponding to the selected option.
0 Connect messages are controlled by the
command settings X, W, and S95.
1 Connect messages are displayed in the single
line format described below subject to the
command settings V (Verbose) and Q (Quiet). In
Non-Verbose mode (V0), single line connect
messages are disabled and a single numeric
result code is generated for CONNECT DTE.
When single line connect messages are enabled, there are no CARRIER, PROTOCOL
(+ER:), or COMPRESSION (+DR:) messages apart from the fields described below.
The single line connect message format is:
CONNECT <DTE Speed>/<Modulation>/<Protocol>/<Compression>/
<Line Speed>
Where:
DTE Speed = DTE speed, e.g., 57600.
Modulation = “V92” for V.92 modulation.
“V90” for V.90 modulation.
“V34” for V.34 modulation.
“V32” for V.32 or V.32bis modulation.
Note: Modulation is omitted for all other modulations.
Protocol = “NONE” for no protocol.
“ALT” for Microcom Network Protocol.
“LAPM” for LAP-M protocol.
Compression = “V44” for V.44 compression.
“V42B” for V.42bis compression.
“ALT” for Microcom MNP5 compression.
Note: Compression is omitted if protocol is NONE.
Line Speed = Asymmetric rates are displayed as “/rate:TX/rate:RX”, e.g.,
/1200 TX/75 RX.
Symmetric rates are displayed as a single DCE rate, e.g.,
14400.