Futaba 8FGAS, 8FGHS 2.4GHz - Manual (Page 102)

102 <Model Menu (Airplane/Glider Functions)>
● Select the function name
and return to the Model
menu by touching the
RTN button.
<SensorTouch™>
ELE to CAMBER [Corresponding model type]: Airplane/glider, 2 ailerons or more
This function is used when you want to mix the
camber flaps with elevator operation. When used,
the flaps are lowered by up elevator, and lift is
increased.
● In-flight mixing can be turned ON/OFF by assigning
this to a switch. (Always ON at [--] setting)
● The mixing rate can be adjusted.
● The range that mixing does not work near the
neutral position of the elevator stick can be
adjusted. (Glider only)
Note: The elevator on the tailless wing will also
be effected when this mix is activated.
●Mixing rate adjustment
Move the cursor to the up or down mixing
rate item for each servo and touch the RTN
button to switch to the data input mode.
Adjust the rate independently by scrolling
the touch sensor.
Initial value: 0%
Adjustment range: -100~+100%
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
Touch the RTN button to end the adjustment
and return to the cursor mode.
Setting method
●Activate the function
Move the cursor to the [ACT] item and touch
the RTN button to switch to the data input
mode. Select the ACT mode by scrolling the
touch sensor.
*The display blinks.
Touch the RTN button to activate the
function and return to the cursor mode. (ON
is displayed.)
When setting a switch, move the cursor to
the [SW] item and touch the RTN button to
call the selection screen. Select the switch
and set its ON direction. (Always ON at "--"
setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Range setting (Glider only)
Move the cursor to the [RANGE] item and
hold the elevator stick to the desired position
(upper or lower side) and then touch the RTN
button for one second to set the range.
*The mixing does not work near neutral of the elevator stick.
Initial value: 0%
Adjustment range: 0~100%
(Glider: Currently selected condition name)
● Select [ELE to CAMBER] at the Model
menu and access the setup screen
shown below by touching the RTN
button.
*The display screen is an example.
The actual screen depends on the
model type.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page