Futaba 8FGAS, 8FGHS 2.4GHz - Manual (Page 22)

22 <Basic Operation>
BASIC OPERATION
How to charge the Ni-MH battery HT6F1700B
for the transmitter

Danger
 The Ni-MH battery HT6F1700B is only for
your T8FGS, T8FG and T12FG. Do not use
this battery for other equipment.
 Be sure to use the attached special charger to
charge the battery.
*If you take out the Ni-MH battery HT6F1700B from the
transmitter, you can use the optional quick charger CR-2000
corresponding to Ni-MH battery.
[Method of charging battery]
*Connect to AC outlet
specified.
●Special charger
Transmitter Batt.
Charging display
Receiver Batt.
Charging display
To T8FGS charge
connector
1. Connect the special charger to the wall
socket (AC outlet).
2. Connect the connectors to the T8FGS
charging connector.
*Confirm that the charging indicator, LED lamp, is on.
*Turn off the transmitter while charging the battery.
3. Remove the battery after 15 hours.
*Battery charging will not automatically stop. Remove the
battery and transmitter from the charger and remove the
charger from the wall socket.
*It is recommended to reactivate the battery by cycling
several times if the battery has not been used for a long
period.
*In the case of Ni-MH/Ni-Cd batteries, you may find poor
performance of the battery if you have used the battery
only for a short period or if you repeat charging while the
battery is not fully discharged. It is suggested to discharge
the battery to the recommended level after use. It is also
recommended to charge the battery just before use.
Battery Charging
Before charging batteries, read the "Cautions for handling battery and battery charger" in the section "Ni-
MH/Ni-Cd Battery Safety and Handling Instructions".