Futaba 8FGAS, 8FGHS 2.4GHz - Manual (Page 64)

64 <Functions of Linkage Menu>
● Select the function name
and return to the Linkage
menu by touching the
RTN button.
<SensorTouch™>
FUNCTION Channel assignment of each function can be changed.
When you select model and wing (swash) types,
you will find that the optimized combinations of
servo output channels and functions have been
already preset. If you would like, you can freely
change combinations of servo output channels,
functions (aileron, elevator, etc), and control (sticks,
switches, and trim levers).
*You can also assign the same function to multiple servo
output channels such as assigning elevator function to CH2
and CH3.
Channel Replacement
When the channel is replaced by using this
channel replacement function, the replacement is
automatically done as for the setting data (ATV,
SUB-TRIM, REVERSE, F/S, and B-F/S, etc.) set
to those channels respectively.
V1~V4 (virtual channels)
These four channels can be set as virtual
functions that do not have servo output channels.
You can freely change combinations between
functions (aileron, elevator, etc) and input controls
(sticks, switches, and trim levers).
Function change
1. Move the cursor to the function item of the
channel you want to change and touch the
RTN button.
*The function selection screen is displayed.
2. Move the cursor to the function name you
want to set and touch the RTN button.
*The function name blinks.
3. Touch the RTN button to execute the
change. (When you want to cancel this
operation, touch the S1 button.)
*Multiple channels can be assigned to one function.
Servo Output Channels
For FASST MLT2 mode, you can set 12 linear
channels and two digital channels. For FASST
MULT mode, you can set 8 linear channels and two
digital channels. For FASST 7CH mode, you can
set only seven linear channels.
*DG1/2 (digital channels)
These channels can function as switched channels. You can
freely change combinations between servo output channels
and input controls (sticks, switches, and trim levers).
Motor Function
If you have either a Glider or Airplane Model
Type selected, and choose to activate the Motor
function, a reverse setting screen is displayed.
*If YES is selected, the output is reversed. If NO is selected,
the output is normal.

WARNING
 As a safety precaution to prevent the motor
from starting unexpectedly, please switch
off the motor accordingly. We also suggest
removing the propeller from the motor as an
additional precaution.
Operation control change
1. Move the cursor to the "CTRL" item of the
channel you want to change and touch the
RTN button.
*The control selection screen is displayed.
2. Move the cursor to the control you want to
change, and touch the RTN button.
*The same control can be assigned to multiple channels.
Camber/Motor/Butterfly control setting (glider)
*Camber/Motor/Butterfly function control can be changed for
each condition.
(The display screen is an example. The
screen depends on the model type.)
● Select [FUNCTION] in the Linkage menu and
access the setup screen shown below by touching
the RTN button.
● Trim operation mode
"COMB": Combination mode
"SEPAR": Separate mode
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page