Futaba 8FGAS, 8FGHS 2.4GHz - Manual (Page 133)

133 <Functions of Model Menu (Helicopter Functions)>
● Select the function name
and return to the Model
menu by touching the
RTN button.
<SensorTouch™>
GOVERNOR mixing
When using a Futaba GV-1/GY701/CGY750
governor, this function is used to switch the RPM
of the helicopter's rotor head. The rotor head speed
can be switched with each condition or the switch.
*The governor is used by connecting the governor speed
setting channel to CH7 (initial setting).
*When using an independent governor [ON]/[OFF] switch,
connect the AUX([ON]/[OFF]) connector of the governor to
CH8 and set the switch to CH8 (Governor2) at the Function
menu of the Linkage Menu.
Note: Always set (Control) and (Trim) to [--]
for [Governor] of the Function menu of the
Linkage menu.
● Select [GOVERNOR] at the Model menu and
access the setup screen shown below by
touching the RTN button.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
COND NORMAL INH
NORMAL
MODE %
FINE TUNING
RATE 50.0 %
-- +0% ( +0%)
< 50.0%>
GOVERNOR
(Currently selected condition name)
●Unit display selection:
[%]/[rpm]
●Setup screen selection
●ACT/INH: INH (initial setting)
●Fine tuning VR settings
●RPM adjustment
●Condition/Switch selection
Setting method
●Activate the mixing
When using this function, move the cursor to
the [INH] item and touch the RTN button to
switch to the data input mode.
Select the ACT mode by scrolling the touch
sensor.
*The display blinks.
Touch the RTN button to activate the mixing
and return to the cursor mode. (ON is
displayed.)
When the Governor is changed from the
default inhibited (INH) state to the active
(ACT) state, the endpoint menu will be
displayed and it is possible to utilize the
endpoints for this given condition.
*When the function is set ON/OFF at the governor setup
screen, the governor rpm setting channel end point servo
travel and limit point are now initialized.
*When changed from INH to ACT (ON), the servo travel is
initialized to 100 and the limit point is initialized to 155.
*When operation is changed to INH at all conditions, the
servo travel is initialized to 100 and the limit point is
initialized to 135.
Use the SensorTouch to scroll to either YES
(incorporate the default endpoints) or NO
(endpoints are not utilized. Press the Return
(RTN) button to confirm the selection made.
●RPM adjustment
Move the cursor to the rate item and touch
the RTN button to switch to the data input
mode.
Adjust the rpm by scrolling the touch sensor.
Initial value: 50% (1500rpm)
Adjustment range: OFF, 0~110% (OFF,
700~3500rpm)
*When the RTN button is touched for one second, the
sensitivity is reset to the initial value.)
Touch the RTN button to return to the cursor
mode.
●Unit diplay selection
Move the cursor to the UNIT item and touch