Pit curve – Futaba 8FGAS, 8FGHS 2.4GHz User Manual

Page 90

Advertising
background image

90

<Model Menu (Airplane/Glider Functions)>

● Select the function name

and return to the Model

menu by touching the

RTN button.

<SensorTouch™>

This function adjusts the pitch curve for VPP

(Variable Pitch Propeller) airplane.

*Up to 3 conditions can be set.
*The priority increases in condition 1→2→3 order.

NOTE: When VPP is not assigned to any

channel, the pitch curve is not displayed in

the model menu. In this case, assign VPP to

any channel on the function screen.

● Select [PIT CURVE] at the Model menu

and access the setup screen shown

below by touching the RTN button.

●Curve rate

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

PIT CURVE

[Corresponding model type]: Airplane, general

Setting method
●VPP condition selection

1. Move the cursor to the # button at the top

right side of the screen and touch the RTN

button to switch to the data input mode.

Select the VPP condition by scrolling the

touch sensor.

*The display blinks.

Touch the RTN button to call the setting

screen and return to the cursor mode.

2. Move the cursor to the switch item and

touch the RTN button to access the selection

screen. Select the switch and set its ON

direction.

*For a description of the switch selection method, see the

description at the back of this manual.

Set the VPP condition 2 and 3 switch.

*The VPP conditions can also be checked at the HOME

screen.

●5-point curve setting

[Curve rate setting]
1. Move the cursor to the curve rate setting

item you want to adjust and touch the RTN

button to switch to the data input mode.

Adjust the rate by scrolling the touch sensor.
Initial value: 0%
Adjustment range: 0%~100%

*When the RTN button is touched for one second, the rate is

reset to the initial value.)

Touch the RTN button to end the adjustment

and return to the cursor mode.

2. Repeat this procedure for each point.
[Moving curve point]
1. Move the cursor to the curve point setting

item you want to adjust and touch the RTN

button to switch to the data input mode.

Adjust the curve point by scrolling the touch

sensor.

Initial value: P1: (0%), P2: 25%, P3: 50%, P4:

75%, P5: (100%)

Adjustment range: Up to 2.5% in front of the

adjoining point

*When the RTN button is touched for one second, the curve

position is reset to the initial value.)

Touch the RTN button to end the adjustment

and return to the cursor mode.

2. Repeat this procedure for each point.

[Deleting/returning curve point]
Move the cursor to the curve point setting

item you want to delete/return and touch

the RTN button for one second.

●Curve point

Advertising