Trim mix – Futaba 8FGAS, 8FGHS 2.4GHz User Manual

Page 106

Advertising
background image

106

<Model Menu (Airplane/Glider Functions)>

● Select the function name

and return to the Model

menu by touching the

RTN button.

<SensorTouch™>

TRIM MIX

[Corresponding model type]: Glider, 2 ailerons or more

This function adjusts the trim offset rates of the

ailerons, elevators, and flaps (camber flaps, brake

flaps) according to the flight status.

As an example this function can be set up for

launching, with speed flaps and ailerons drooped,

and a slight amount of up elevator, and can be

used for high speed flying, with both ailerons and

speed flaps reflexed slightly, and a bit of down

elevator.

To prevent sudden trim changes when switching

flight conditions, a delay can be set to provide a

● Select [TRIM MIX] at the Model menu

and access the setup screen shown

below by touching the RTN button.

*The display screen is an example. The actual

screen depends on the model type.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

smooth transition between the two conditions. It

is also possible to program a cut switch which

will turn off the delay.

Furthermore, you can set the auto switch, which

will link the trim mix to a stick, switch, or dial.

Additionally, the speed of the aileron, elevator,

and flap servos can be adjusted.

(Currently selected condition name)

● Condition delay

setting

● Ailerons, flaps, and

elevators servo speed

setting

●Auto switch selection

● A i l e r o n s , f l a p s , a n d

elevators offset rate

● S w i t c h

selection

Advertising