Futaba 8FGAS, 8FGHS 2.4GHz - Manual (Page 60)

60 <Functions of Linkage Menu>
Model deletion
*The model stored in the transmitter memory or an SD card
can be deleted.
*The current model can not be deleted.
1. Move the cursor to the save destination
display ("TX" or "CARD") and touch the RTN
button to switch to the data input mode.
Select the save destination by scrolling the
touch sensor and touch the RTN button.
[TX]: Transmitter memory
[CARD]: SD card
2. Move the cursor to the model you want to
delete in the model list and then touch the
RTN button.
3. Move the cursor to [DELETE].
4. Touch the RTN button. When a confirmation
message is displayed and the RTN button
is touched for one second, the model is
deleted.
Model name change
*The model name of the model stored in the transmitter
memory or a SD card can be changed.
1. If changing the location:
Move the cursor to the save destination
display ("TX" or "CARD") and touch the RTN
button to switch to the data input mode.
Select the save destination by scrolling the
touch sensor and touch the RTN button.
[TX]: Transmitter memory
[CARD]: SD card
2. Move the cursor to the model you want to
change in the model list and then touch the
RTN button.
3. Move to [RENAME].
4. Touch the RTN button.
*The model name setup screen is displayed.
User name (candidate)
4. Change the model name as described
below:
[Moving cursor in the user name (candidate)]
Select [←] or [→], and touch the RTN button.
[Deleting a character]
When [DELETE] is selected and the RTN button
is touched, the character immediately after
the cursor is deleted.
[Adding a character]
When a character is selected from the
character list and the RTN button is touched,
that character is added at the position
immediately after the cursor.
*A name of up to 10 characters long can be entered as the
model name. (A space is also counted as one character.)
5. After the desired information has been input,
select [ENTER] and touch the RTN button.
(To terminate input and return to the original
state, select [CANCEL] and touch the RTN
button.)
Model copy
*A copy can be made of the model stored in the transmitter
memory or an SD card.
1. If changing the location:
Move the cursor to the save destination
display ("TX" or "CARD") and touch the RTN
button to switch to the data input mode.
Select the save destination by scrolling the
touch sensor and touch the RTN button.
[TX]: Transmitter memory
[CARD]: SD card
2. Select the model you want to copy in the
model list and then touch the RTN button.
2. Move to [COPY].
3. Touch the RTN button.
*The copy screen appears.
4. If replacing the model stored in the
transmitter memory:
Move to [ADD-LIST] and touch the RTN button
to switch to the data input mode.
Select the destination model by scrolling the
touch sensor and touch the RTN button.
[ADD-LIST]: adding the model to the list
[(model name)]: replacing the model
*The model stored in the SD card can be replaced.
If changing the location:
Move the cursor to the copy destination
display ("TX" or "CARD") and touch the RTN
button to switch to the data input mode.
Select the save destination by scrolling the
touch sensor and touch the RTN button.
5. Move to [COPY].
6. Touch the RTN button. When a confirmation
message is displayed and the RTN button is
touched for one second, the model data is
copied.