Futaba 8FGAS, 8FGHS 2.4GHz - Manual (Page 63)

63 <Functions of Linkage Menu>
● Select the function name
and return to the Linkage
menu by touching the
RTN button.
<SensorTouch™>
FASST mode selection
The receiver type will determine whether you
utilize MULTI(MLT2/MULT) or 7CH setting in
"FASST".
MLT2/MULT: FASST-2.4GHz system Multi-ch mode
7CH: FASST-2.4GHz system 7ch mode
*Select the MLT2 or MULT setting for all Futaba FASST-
2.4G Multi-ch mode receivers, regardless of number of
channels (e.g., R6208SB/R6108SB/6008HS/R6014HS/
R608FS/R6014FS).
7CH setting for all Futaba FASST-2.4G 7ch mode receivers,
regardless of number of channels (e.g., R6004FF/R616FFM/
R607FS/R617FS).
For the most up-to-date list of receivers and their
respective compatibility, please refer to our web site at:
http://2.4gigahertz.com/receivers/index.html
FREQUENCY FASST mode selection and area mode selection
FASST mode selection
1. Move the cursor to the "FASST" item and
touch the RTN button to switch to the data
input mode.
Select the mode by scrolling the touch
sensor. A confirmation message appears.
Touch the RTN button to change the mode.
(To terminate input and return to the original
state, touch the S1 button.)
*Transmission stops and then starts in the mode selected.
*When MLT2 mode is selected, the 12 linear CH output
mode is activated. In the MLT2 mode, 1-12CH setting is
possible on the function/sub-trim/servo reverse/fail safe/end
point/trainer screens. Virtual channels cannot be used in the
MLT2 mode.
*When MULT mode is selected, the 8 linear CH output and
the 4 virtual CH mode is activated.
Area mode selection (Frequency range)
The T8FGS transmitter has been designed
to function in many countries. If you will be
utilizing this transmitter in a country other than
France, please make sure that [AREA] is set to
"GENERAL". If, however, this transmitter will be
utilized in France, it must be set to "FRANCE" in
order to comply with French regulations.
Area mode selection
1. Move the cursor to the "AREA" selection and
touch the RTN button to switch to the data
input mode.
Select the Area by scrolling the touch sensor.
A confirmation message appears. Touch
the RTN button to change the mode. (To
terminate input and return to the original
state, touch the S1 button.)
*Transmission stops and then starts in the mode selected.
● Select [FREQUENCY] in the Linkage menu and
access the setup screen shown below by
touching the RTN button.
Scrolling
● Moving cursor
● Selecting mode