Futaba 8FGAS, 8FGHS 2.4GHz - Manual (Page 131)

131 <Functions of Model Menu (Helicopter Functions)>
● Select the function name
and return to the Model
menu by touching the
RTN button.
<SensorTouch™>
GYRO mixing
This function used to adjust gyro sensitivity.
The sensitivity and operation mode (Normal mode/
AVCS mode) can be set for each condition.
The gyro sensitivity can be switched with each
condition or the switch. (5 sensitivities)
*Compatible with 3 axis gyro(CGY750).
● Select [GYRO] at the Model menu and access the
setup screen shown below by touching the RTN
button.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
Note: When using the [Gyro2]/[Gyro3] function,
assign [Gyro2]/[Gyro3] to any channel on the
function screen.
Always set to [--] both (Control) and (Trim) for
the [Gyro] function at the Function menu in
the Linkage menu.
(Currently selected condition name)
●Mode selection:
[AVCS]/[NORM]
●Gyro type selection:
[GY]/[NORM]
●Setup screen selection
●ON: (initial setting)
●Fine tuning VR settings
●Gyro sensitivity adjustment
●Condition/Switch selection
●The edit conditions can be
changed by touching the
S1 button.
*When the rate switching setting of
all the gyros is “Switch”, the edit
conditions are not displayed.
●The edit rate can be changed by operating
the edit rate button.
*When the rate switching setting of all the gyros is
“COND”, the edit rate button is not displayed.
●When the GYRO function button is selected,
each GYRO detailed setting screen
appears.