Futaba 8FGAS, 8FGHS 2.4GHz - Manual (Page 57)

57 <Functions of Linkage Menu>
FUNCTIONS OF LINKAGE MENU
The Linkage Menu is made up of functions
which perform model addition, model type
selection, frequency setting, end point setting, and
other model basic settings.
The functions which can be selected depend on
the model type. A typical menu screen is shown
below.
*The display screen is an example. The
screen depends on the model type.
Linkage Menu functions table
[SERVO]: Displays the servo test and operation position
[MODEL SEL]: Model addition, call, deletion, copy, model name setting
[MODEL TYPE]: Model type, wing type, swash type, etc. selection
[FREQUENCY]: FASST mode selection and area mode selection
[FUNCTION]: Channel assignment of each function can be changed
[SUB-TRIM]: Adjusts the neutral position of each servo
[REVERSE]: Reverses the servo travel direction
[FAIL SAFE]: Fail safe function and battery fail safe function setting
[END POINT]: Servo travel adjustment and limit setting
[THR CUT]: Stops the engine safely and easily (airplane and helicopter only)
[IDLE DOWN]: Lowers the idle speed of the engine (airplane only)
[SWASH RING]: Limits the swash plate travel to within a fixed range. (helicopter only)
[SWASH]: Swash AFR and linkage correction function (helicopter only)
[T1-T4 SET.]: Control step amount and mode selection of the digital trim
[WARNING]: Mixing warning normal reset
[DATA RESET]: Model memory set data reset
● Access the Linkage menu shown below by
tapping the LNK button two times.
● Select [LINKAGE MENU]
and return to the home
screen by touching the
RTN button.
<SensorTouch™>
● Select the function you want to set and call
the setup screen by touching the RTN button.
●Calling setup screen
Scrolling
● Moving cursor