Cygnion CG 2400 - Manual (Page 175)

C
h
apte
r 7
:
Ca
ll
s f
rom
the
H
a
nds
e
t
163
Selecting Which Phone
Line to Use
If you have two external phone lines connected to
your base station, you can select a specific line for
outgoing calls when your handset is idle (no call in
progress).
To select a specific phone line:
1. Press to activate the handset menu.
2. Select >Retrieve, then select Line1 or Line2.
One of the following will happen:
Parking a Call
Call parking allows you to place a call on “hold” in
such a way that another user may pick it up.
If the call remains parked for more than two
minutes, CyberGenie pages the handset that parked
the call.
If the call continues to remain parked, or if the
handset the call was parked from does not answer or
is turned off, CyberGenie will route the call to the
user’s forwarding destination. (See “Setting Call
Routing” on page 95.)
If... Then...
The line selected is
idle (no active call) You will hear a dial tone
The line is in use by
another CyberGenie
handset You will hear two beeps and
the handset display will show
Not Allowed
A call is parked on
the line selected The parked call will be
connected to your handset
A call is in progress
on that line You will be connected to the
call without disconnecting
the current user