Cygnion CG 2400 - Manual (Page 197)

C
h
a
p
te
r 8
:
Ha
n
d
se
t C
u
st
o
m
iz
a
tio
n
185
To use the headset:
1. Connect the headset to your handset by plugging
it into the jack on the right side of the handset.
The handset will automatically detect the headset
presence and adjust performance accordingly.
2. Use the volume control keys on the handset to
adjust the volume to a comfortable level. A
warning tone will indicate when maximum or
minimum volume has been reached.
The inline button on the headset cord provides the
following features:
•
Press the button to connect to an incoming call.
• Press the button to disconnect an active call.
• Press the button to transfer from an active call to
a call on hold.
• Press to start a CyberGenie session when there
are no active calls.
• Press to end a CyberGenie session.
Automatic Answering with
a Headset
When a headset is attached to your handset, you can
set your handset to answer incoming calls
automatically. This allows full hands-free operation.
With automatic answering, when a call comes in, you
will hear a one-second beep in your headset
accessory, and the phone will also ring, then the call
will connect. The headset speaker and microphone
levels automatically adjust when attached.
To turn automatic answering on or off:
1. Press to access and move through the
menu.
2. Select >Settings >Handset >AutoAnswer and
press .
3. Select On or Off.
4. Press
to confirm selection.