Cygnion CG 2400 - Manual (Page 4)

The B
a
se
St
atio
n
iv
iv
Safety Information a. Safety Standards conformance: UL 1950 Third Edition
b. CSA C22.2 No. 950-95 Third Edition
EMC Regulations:
a. FCC, CFR Title 47, Subchapter 15, Subpart C
b. Industry Canada (IC) RSS-210
Telecommunication Regulation:
a. FCC, CFR Title 47, Subchapter 68
b. IC CS 03 Parts I, II, V, VI, VII & VIII
Manufacturer’s Declaration of Conformity (DoC)
Cygnion Corporation
41 Discovery, Irvine, California 92618, U.S.A.
We declare under our sole responsibility that the CG 2400 system (Base
Station Model DA 202, Handset Model DG 200 and Handset Charger Model
XA 200) conforms to the following specifications:
The limits for Class B digital device, pursuant to Part 15 of FCC Rules and
IC RSS-210, operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
FCC Part 68 and IC CS-03:
This equipment complies with FCC Rules Part 68 and Industry of Canada IC
CS-03. Located on the back of the base station is the FCC registration
number and ringer equivalence number (REN). You must provide this
information to the phone company if requested.
The REN is useful to determine the number of devices you may legally
connect to your telephone line and still have all of those devices ring when
your telephone number is called. In most areas, but not all areas, the sum of
the RENs of devices connected to one line should not exceed five (5). To be
certain of the number of devices you may have connected to your line, as
determined by the REN, you should contact your local telephone company
to determine the maximum RENs for your calling area.
Hearing-aid wearers: The CG 2400 system is compatible with inductively
coupled hearing aids.
UL/cUL:
This equipment is UL-listed and cUL-listed for use with UL-listed personal
computers and complies with UL 1950/CSA C22.2 No. 950-95 Third Edition.
Safety Precautions: To reduce the risk of fire, use only No. 26 AWG or
larger telecommunication line cord.
Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the manufacturer. Dispose of
used batteries according to the manufacturer's instructions.
The rechargeable nickel metal hydride (NiMH) battery pack must be
recycled or disposed of properly. Do not dispose of in municipal waste.
Check with your local solid waste offices for details in your area for recycling
options or proper disposal.
Do not open or mutilate the batteries. Released electrolytes may cause
damage to the eyes or skin. The electrolytes may be toxic if swallowed.
Avoid contact with water or fire. DO NOT dispose of batteries in a fire; the
cells may explode. Check with local codes for special disposal instructions.