Talkswitch 48-CVA - Manual (Page 127)

122 TalkSwitch User Manual
Touch-tone features dialed at the Auto Attendant message from outside phones
Digit dialed
0
1x1-1x4
1x1-1x8
2x1-2x8
250-299
300-309
1,2,3,4,5
6
7(xxx...)
81-88, 9
80
1x1-1x8
2x1-2x8
4x0-4x9
4x0-4x9
1x1-1x8
2x1-2x8
4x0-4x9
Function performed
User Defined – An Extension, Ring Group, Auto Attendant,
Voice mailbox, Announcement or perform no action.
Dials Local Extensions. x represents the Unit ID number.
Dials Remote Extensions associated with an external phone
number. x represents the Unit ID number (1-4).
Speed dial for VoIP calls. TalkSwitch will hunt the VoIP ports,
go off hook, then dial the digits entered.
Dials Extension Ring Groups – 10 in total for the entire
system. Mapped to Local Extensions(s), with specific fall
through options.
User Defined – An Extension, Ring Group, Auto Attendant,
Voice mailbox, Announcement or Perform no action.
Enters Call Back configuration.
PBX Transfer - A flash hook transfer with disconnect after
dialed. Usually used only in systems connected to another PBX.
Access to line Hunt Groups for Call Bridge - Password
protected at the Auto Attendant.
Call Bridge using Same Line Connect. Requires 3-Way
Calling/Conference on the line.
Enter Internal voicemail to leave a message or listen to an
announcement. If you press 8 during the greeting, you can
access messages. x represents the Unit ID number.
Callers can directly also dial 400 series mailboxes
Internal voicemail retrieval/access.
x represents the Unit ID number.
TS manual 11th ED_CVA_v11_CD_Release.qxd 7/13/2004 3:36 PM Page 122