Talkswitch 48-CVA - Manual (Page 39)

29 3.0 Configuring TalkSwitch
Busy Forwarding Options:
This section allows you to configure how inbound calls are handled for each port
when it is busy. You can click ‘Assign ports’ to assign ports for busy forwarding
when the port associated to this phone number is busy. This feature is similar to
the phone company’s Rollover/Busy Forwarding service. By default this feature is
enabled so that the maximum number of inbound calls can be handled by the
system at any one time.
3.3.1.6 Line Hunt Groups
There are a total of 9 Line Hunt Groups for controlling outbound call line selections.
These Line Hunt Groups are used by the Local and Remote Extensions, and when
using the Call Bridge feature. Each Hunt Group can support several line choices and
will attempt to grab an available line in the order that they are listed (Lines to hunt)
for that Hunt group. These settings have no effect on incoming calls.
Default setup:
Hunt Group 9: selects any available telephone line
Hunt Group 81: selects telephone Line 1
Hunt Group 82: selects telephone Line 2
Hunt Group 83: selects telephone Line 3
Hunt Group 84: selects telephone Line 4
Hunt Group 88: selects any available VoIP line
First select a Line Hunt Group then enter a useful name for identifying this hunt
group elsewhere in the configuration software.
Under Set Line Hunt Group, select the Line Type. If you wish to use this hunt group
TS manual 11th ED_CVA_v11_CD_Release.qxd 7/13/2004 3:34 PM Page 29