KERN & SOHN DBS 60-3 - Manual (Page 42)

42 DBS-BA-e-1311
8.2 Abort drying
 The measuring can be aborted at any time by
pressing the STOP button. A long signal will sound,
and “ABORT” will be displayed.
Either
 Press ESC key. The equipment reverts to Moisture
analysis mode and the measuring result is
discarded.
or
 Press STOP key again.
The measuring result, marked by the indicator [ ]],
will be displayed and saved.
8.3 Finish drying
 Open heated cover
! Observe hazard information,
see Chapter 3.5 “Hazards during and after
measuring”
! Careful when removing the sample. The sample
itself, the sample dish and the heating unit may be
very hot.
! Always work with a removal aid as this will enable
safe working and prevent burns.
If you will repeat measurement for the same
sample
 Press START key to measure the same
sample after the measurement successively.
If you switch the mode to manual start, you
can measure successively after resetting the
measuremaent result.
8.4 Turn off appliance
 Press ON/OFF button until “OFF” appears and the
display will change to “READY”. The equipment
migrates to Ready mode.
The moisture analyser does not require any warm-
up time in Ready mode in order to be used for
measuring.
 The equipment must be disconnected from the
mains in order to switch the power supply off
completely.