KERN & SOHN DBS 60-3 - Manual (Page 52)

52 DBS-BA-e-1311
4. Preset drying time for step 1
 Press ENTER to confirm. The currently preset
drying time for step 1 will be displayed.
 Use navigation buttons   to select the
required setting, 1 minute – 4 hours (1 minute
increments) can be selected
5. Set drying temperature for step 2
 Press ENTER to confirm and the currently
preset drying temperature for step 2 will flash
in the display.
 Use navigation buttons   to select the
required setting,
50°C – 200°C (1°C increments) can be
selected.
6. Set drying time or
∆M for step 2
 Acknowledge using ENTER key, the current
setting is displayed.
 Use navigation buttons   to select switch-
off criterion (TIME or
∆M) for step 2.

Setting
∆M
 Press ENTER to confirm selection. The
currently preset value for
∆M will be
displayed.
 Use navigation buttons   to select the
required setting, 0.01% – 0.1% (0.01%
increments) can be selected.
or
TIME setting
 Press ENTER to confirm selection. The
currently set drying time is displayed.
 Use navigation buttons   to select the
required setting, 0 minutes – 240 minutes
(1 minute increments) can be selected
If 0 minutes are entered, the next step will be
cancelled.
 Press ENTER to confirm.
Continue from step 8 for 2-step drying.
Continue from step 7 for 3-step drying.