KERN & SOHN DBS 60-3 - Manual (Page 47)

DBS-BA-e-1311 47
9.2.1.3 RAPID Drying mode (Rapid drying)
A preheating step is switched on for Rapid drying, i.e. the temperature will increase
very quickly and will exceed the preset drying temperature until it falls below the
preset reference value (weight loss/30 sec).
After that the temperature will be adjusted down to the set value. The drying will end
depending on the setting, when the preset time has expired or the preset weight loss
(
∆M) remains constant for 30 seconds.
Rapid drying is suitable for samples with high moisture content (e.g. liquids).
Settings:
• RAPID Drying mode
• ∆M “pre-heating step”
• Drying temperature
• Drying time switch-off criterion or ∆M
 Press the Menu button to access the menu and
the first menu item “PRoGRM” will be displayed.

 Press navigation button , then use navigation
buttons   to select “RAPID”.
 Press ENTER to confirm and the currently preset
reference value for the preheating step will flash
in the display.
0.1% -9.9% (0.01% increments) can be selected
 Press ENTER to confirm and the currently preset
drying temperature will flash in the display.
 Use navigation buttons   to select the
required setting,
50°C – 200°C (1°C increments) can be selected.