KERN & SOHN FA 6T-3M - Manual (Page 28)

28 KFB/KFN-TM-BA_IA-e-1220
 Press and the current setting for the upper limit will be
displayed.
 Press the navigation keys (See chap. 2.1.1) to enter the
upper limit, e.g. 1,100 kg; the currently enabled digit will be
flashing.
 Confirm input by .
 Use to select
 Press and the current setting for the acoustic signal will
be shown.
 Select desired setting (no, ok, ng) by .
 Confirm input by .
 Press repeatedly; weighing system is in tolerance
weighing mode. From here evaluation takes place whether
the goods to be weighed are within the two tolerance limits.
Weighing with tolerance range
 Tare when using a weighing container
 Put on goods to be weighed, tolerance control is started The signal lights
indicate whether the load is within the two set limits.
Load below specified
tolerance
Load within specified
tolerance
Load exceeds specified
tolerance
Red signal light
next to „-“ ON illuminated
Green signal light
next to „„ illuminated
Red signal light
next to „+“ ON illuminated
• The tolerance control is not active when the weight is under 20d.
• To delete limits, enter “00.000 kg“.