KERN & SOHN FA 6T-3M - Manual (Page 37)

KFB/KFN-TM-BA_IA-e-1220 37
8.1 Overview non verifiable weighing systems
(contacts of circuit board [K1] not short-circuited)
Menu block
Main menu Menu item
Submenu
Available settings / explanation
PO CHK
Weighing with
tolerance range,
see chap. 7.7
SET H Upper limit value, input see chap. 7.7
SET LO Lower limit value, input see chap. 7.7
PCS H Not documented
PCS L Not documented
BEEP no
Acoustic signal for weighing with tolerance range
switched off
ok Audio sound when load is within tolerance limits
nG Audio sound when load is beyond tolerance limits
P1 REF
Zero point
settings
A2n0 Automatic zero point correction (Autozero) by changing the
display, digits selectable (0.5d, 1d, 2d, 4d)
0AUto Zero setting range
Load range where the display after switching-on the
balance is set to zero. Selectable 0, 2, 5, 10, 20, 50, 100
%
0rAGE Zero setting range
Load range where the display is set to zero by pressing
. Selectable 0, 2, 4, 10 , 20* , 50, 100%.
0tArE Automatic taring „on / off“, taring range adjustable in menu
item „0Auto“.
SPEEd Not documented
Zero Zero point setting
P2 COM
Interface
parameter
MODE CONT Continuous data output
ST1 One output for stable weighing value
STC Continuous data output of stable weighing
values
PR1
Output after pressing
PR2 Manual totalizing, see chap. 7.8.
Press and the weighing value will be
added to the summation memory and issued.
AUTO* For automatic add-up see chap. 7.9.
This function is used to issue and add individual
weighing values automatically to the summation
memory on unloading of weighing scale.
ASK For remote control commands, see chap. 10.4
wirel
Not documented
kit 1
BAUD Available Baudrate: 600, 1200, 2400, 4800, 9600*