PRG Bad Boy Field Service Manual - Manual (Page 26)

18 BAD BOY ® SPOT LUMINAIRE FIELD SERVICE MANUAL
Mechanism Errors
Errors will be shown after the mechanism sub-code, for example: PAN:Comm Error.
Other Errors
Error Code Explanation
Comm Error Error communicating with motion processor
Init Error Error during initialization of motion processor
Cal Error Error resetting position values in motion processor at beginning of calibration
Cal Timeout An action during calibration took longer than expected
No Stop Mechanism which calibrates to a physical stop did not find that stop
Sensor Stuck During calibration, could not find either edge of the sensor or the sensor did not turn off as expected
No Sensor During calibration, no sensor was found in the range of travel
Hall Sensor Edge Found sensor, but couldn't find far edge
Motion Error Mechanism's actual position is too far from its commanded position
Command Error Error while sending commands to the motion processor
Get Position Error Error when retrieving current position from motion processor
Spin Error Error while sending spin command to motion processor
Stop Spin Error Error while sending stop spin command to motion processor
Spin Stop Timeout Spinning mechanism did not come to rest in the given period
Error Code Explanation
Temp over threshold Temperature too high
Lamp over threshold Lamp hours above recommended maximum
Lamp Off Fan Error: Cannot strike lamp while any fan is in error state
Pan/Tilt Aux Encoder Error Auxiliary encoder value is too far from the main encoder value
Gobo out of zero range When zeroing gobo wheels, the wheel is too far away from zero to set the position
DMX busy: cancel crossload Cannot execute crossload with traffic on DMX line
Data not crossload format Data in memory is not proper format for crossload
DMX: UART transmit error Transmit buffer busy when trying to send
Crossload Timeout Crossload execution took too long due to error
CAN Comm Error Stopped receiving CAN messages from motion processor
Main Fan Error Main fan CAN messages not received or fan not running properly
UPE Fans Error Upper Enclosure fans not running properly
Pinch Fan Error Pinch fan not running properly
Stack Fan Error One or more stack fans not running properly