PRG Bad Boy Field Service Manual User Manual
Page 88
80
BAD BOY
®
SPOT LUMINAIRE FIELD SERVICE MANUAL
Step
7. Move Pan Cable Routing Plate out of the way enough to access belt and pulley.
Step
8. At Pan Drive Assembly, loosen (but do not completely remove) four 10-32 x 5/8" socket head screws. This
will begin to loosen the belt.
Step
9. Release belt tension by loosening two belt adjustment screws and slip belt off of pan pulley (Figure 3-41).
Step 10. Remove four 10-32 x 5/8" socket head screws and two #10 flat washers from Pan Drive Assembly.
Step 11. At Bus Bar,
remove
screw on left-hand side and
loosen
screw on right-hand side. Rotate Bus Bar up and
out of the way. (This will make it easier to remove the Pan Drive Assembly.)
Step 12. Remove Pan Drive Assembly from yoke.
Step 13. Replace Pan Drive Assembly by doing steps in reverse.
Step 14. Set proper belt tension. Refer to
"Setting Pan/Tilt Belt Tension"
Figure 3-40: Removing Pan Drive Assembly (View 1)
Pan Drive Assembly
10-32 x 5/8"
PFZ Screw (5)
Pulley
Belt
10-32 x 5/8"
Soc Cap Screw (2)
#10 Flat Washer (2)
DETAIL A
Pan Cable
Routing Plate