PRG Bad Boy Field Service Manual - Manual (Page 50)

42 BAD BOY ® SPOT LUMINAIRE FIELD SERVICE MANUAL
REMOVE AND REPLACE PROCEDURES
Replacing the Lamp
Parts:
71.2566.1200.0 1 EA LAMP, FASTFIT, PHILIPS MSR GOLD™
Tools:
Cotton gloves or finger cots
WARNING: Remove power from luminaire before performing any maintenance procedures.
CAUTION: Refer to "Proper Lamp Servicing and Operation" on page 28 before handling the lamp.
To replace lamp:
Step 1. Remove power from lamp and allow lamp to cool for at least 5 minutes.
Step 2. Remove power from luminaire.
Step 3. At rear of luminaire, rotate backcap counter-clockwise to remove (it will still be connected by a tether). Refer
to Figure 3-11 on next page.
Step 4. Remove existing lamp by rotating lamp base counter-clockwise and pulling straight out of backcap.
Step 5. Position new lamp as shown in Figure 3-11 DETAIL A and insert into rear bulkhead. Rotate 45 degrees
clockwise to lock in place. You will hear a click when properly seated.
Step 6. Replace backcap.
Step 7. Reset Lamp Hours. Refer to the Bad Boy User Manual (02.9812.0001).
Step 8. Optimize lamp. (Refer to "Adjusting the Lamp" on page 44.)