PRG Bad Boy Field Service Manual - Manual (Page 75)

BAD BOY ® SPOT LUMINAIRE FIELD SERVICE MANUAL 67
Replacing the Reflector
Parts:
42.9812.0160 1 EA REFLECTOR, 36 LUNES, COATED
Tools:
#2 Phillips screwdriver, long or #2 Philips screwdriver, right-angle
Cotton gloves or finger cots
WARNING: Remove power from luminaire before performing any maintenance procedures.
CAUTION: Do not touch reflector with bare fingers. If dirty, clean with OptiMax™ Ultra Pure Cleaning
Solution and a Micro Fiber cloth.
To replace the Reflector:
Step 1. Remove power from luminaire and allow components to cool for at least 5 minutes.
Step 2. Remove Aft Cover. (Refer to "Removing the Aft Cover" on page 31.)
Step 3. At Reflector, loosen four 6-32 x 1/4" PPB screws to free mounting clips (Figure 3-31).
Step 4. Remove Reflector by carefully sliding out from under XYZ Assembly. (Insulator will come loose during
removal. Do not lose Insulator.)
Step 5. Replace Reflector by doing steps in reverse.
Figure 3-31: Removing Reflector
Reflector
Mounting
6-32 x 1/4"
Insulator
Head Assy
Clip (4)
PPB Screw (4)
XYZ Assembly