PRG Bad Boy Field Service Manual - Manual (Page 84)

76 BAD BOY ® SPOT LUMINAIRE FIELD SERVICE MANUAL
Replacing the Pan/Tilt Controller PCB
Parts:
24.9812.0765 1 EA PCB ASSY, CONTROLLER PAN/TILT
Tools:
#2 Philips screwdriver
WARNING: Remove power from luminaire before performing any maintenance procedures.
CAUTION: Always use anti-static precautions when working with PCBs.
To replace the Pan/Tilt Controller PCB:
Step 1. Remove power from luminaire and allow components to cool for at least 5 minutes.
Step 2. At Tilt Yoke Leg, remove Yoke Cover.
Step 3. At Pan/Tilt Controller PCB, disconnect all cables.
Step 4. Remove Pan/Tilt Controller PCB by removing four 6-32 x 5/16" PPZ screws (Figure 3-37).
Step 5. Replace Pan/Tilt Controller PCB by doing steps in reverse.
Figure 3-37: Removing Pan/Tilt Controller PCB
Pan/Tilt
6-32 x 5/16"
PPZ Screw (4)
Controller PCB
CAUTION:
Use anti-static precautions
when working with PC boards.