PRG Bad Boy Field Service Manual - Manual (Page 53)

BAD BOY ® SPOT LUMINAIRE FIELD SERVICE MANUAL 45
Replacing a Gobo
Parts:
Standard or Custom Gobo(s), as required.
(Refer to
"Standard Gobo Wheel Configuration" on page 11.)
Tools:
#2 Phillips screwdriver
Cotton gloves or finger cots
WARNING: Remove power from luminaire before performing any maintenance procedures.
To replace a gobo:
Step 1. Remove power from luminaire.
Step 2. Locate appropriate head cover door for access to Rotating Gobo Wheel 1 (R1) or Rotating Gobo Wheel 2
(R2) as shown in Figure 3-13. (Doors are identified by a label.) Turn captive screw to open door.
CAUTION: Do not touch gobos with bare fingers. Wear cotton gloves or finger cots when handling.
Step 3. Rotate wheel until desired gobo is accessible.
Step 4. Rotate Color Wheels so that their "open" position lines up next to the gobo you wish to replace. (This will
avoid potential damage to the adjacent wheels as the gobo is being replaced.)
Figure 3-13: Accessing Gobo and Designer Color Wheels
Head Cover Door
R1 Wheel Access
Head Cover Door
R2 and Designer Wheel Access
X
Z
Captive Screw
Captive Screw