PRG Bad Boy Field Service Manual - Manual (Page 61)

BAD BOY ® SPOT LUMINAIRE FIELD SERVICE MANUAL 53
Step 5. At Wheel Stack Assembly, remove four 8-32 x 1/2" socket head screws (Figure 3-20).
Step 6. Verify that Lens Group 1 will not interfere with removal of Wheel Stack Assembly. If lenses are in the way,
turn Group 1 pulley until lenses are clear.
Step 7. Grasp Wheel Stack Assembly on either side and lift straight up and out of luminaire head.
Figure 3-20: Removing Wheel Stack Assembly
Step 8. Replace Wheel Stack Assembly by doing steps in reverse.
Wheel Stack
Assembly
8-32 x 1/2"
SCB Screw (4)
Lens Group 1
C
M Y
Depending on the Bad Boy luminaire
model, the Wheel Stack Assembly will be
different. The CMY Wheel Stack can be
identified by a label on the outer plate.
NOTE: