5 setting gpib, Setup, Interface [tx&rx – Anritsu MP1777A User Manual
Page 23: Time xx ; xx : xx xx/xxx/xx, Fig. 2-3 main setup screen, 5 setting gpib -6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2.5 Setting GPIB
To use GPIB as a remote interface, set the device to the local mode and set the address by performing key input on the
front panel.
Table 2-5 Details of Setting when GPIB Interface is Used
Section 2 GPIB Interface
Details of Setting
Setting Item
Setting Range
Address setting
Address
Oto 30
Perform the setting shown above on the Secondary system screen in the Main setup screen.
(1) (a) Pressing the Setup key causes the Main setup screen to open.
The Main setup screen has "Setup" indicated on the left top section of the screen.
Setup
Interface [Tx&Rx]
Time XX ; XX : XX XX/XXX/XX
Bit Rate
[ 2,488 M ]
Jitter Setting; Equalizer
[ OFF ]
Clock
[ Internal ]
Fig. 2-3 Main setup Screen
(b) Moving the cursor to the shaded section of the figure above and pressing the Setup key causes a window as
shown below to open. To select the Secondary system screen, move the cursor onto "System" using the cursor
key and press the Set key.
2-6
Fig. 2-4 Screen Selection Window
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888)