Safety symbols, Safety symbols used in manual, Safety symbols used on equipment and/or in manual – Anritsu MP1777A User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Safety Symbols
To prevent the risk of personal injury or loss related to equipment malfunction, Anritsu Corporation uses the follow
ing safety symbols to indicate safety-related information. Insure that you clearly understand the meanings of the
symbols BEFORE using the equipment.
Some or all of the symbols may not be used on this equipment. In addition, when drawings are included in this
manual, labels on the equipment may not be shown on them.
Safety Symbols Used in Manual
A KiOCD /\
indicates a very dangerous procedure that could result in death or serious
injury if not performed properly.
1»# * rj 1^11^^ This indicates a hazardous procedure that could result in death or serious injury if
VVMrilNIIMVj
¿_A
not performed properly.
^*1
This indicates a hazardous procedure or danger that could result in light-to-severe
¿-
l
A
injury, or loss related to equipment malfunction, if proper precautions are not taken.
Safety Symbols Used on Equipment and/or in Manual
The following safety symbols are used inside or on the equipment near operation locations, and./or in manual to
provide information about safety items and operation precautions. Insure that you clearly understand the mean
ings of the symbols and take the necessary precautions BEFORE using the equipment.
This indicates a prohibited operation. The prohibited operation is indicated sym
bolically in or near the barred circle.
This indicates an obligatory safety precaution. The obligatory operation is indi
cated symbolically in or near the circle.
This indicates warning or caution. The contents are indicated symbolically in or
near the triangle.
This indicates a note. The contents are described in the box.
These indicate that the marked part should be recycled.
MP1777A
10 GHz Jitter Analyzer Remote Control
Operation Manual Vol. 2
10 September 1998 (First Edition)
20 September 2002 (Fourth Edition)
Copyright © 1998-2002, ANRITSU CORPORATION.
All rights reserved. No part of this manual may be reproduced without the prior written permission of the
publisher.
The contents of this manual may be changed without prior notice.
Printed in Japan
II
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888)