ADLINK PCI-8258 - Manual (Page 106)

92 Motion Control Theory
(c) 200 Hz sine wave
Figure 4-13: Simulation results of notch filter with 100Hz cutoff frequency
See figure below for MCP2's notch filter setup page where you
can workout relevant filter coefficients according to your
specifications. Note: You can set cutoff frequency to zero to close
the notch filter.
Figure 4-14: MCP2 low pass filter setup page
Figure 4-15: MCP2 notch filter setup page
0 0.01 0.02 0.03 0.04 0.05 0.06 0.07 0.08 0.09 0.1
-100
-80
-60
-40
-20
0
20
40
60
80
100
Time(second)
Amplitude
Original Signal
Filtered Signal