ADLINK PCI-8258 - Manual (Page 172)

158 Motion Control Theory
Figure 4-60: Relation of WAIT signals VS motion
Bit11: Point Buffer movement signal - PTB
When point buffer movement is started, this signal is set to ON
and to OFF when movement is completed.
Bit 15: Jog movement signal - JOG
When an axis is doing jog movement, the JOG signal is set to ON
and to OFF when jog movement is completed.
See Section 4.6 for detailed jog movement.
Time
Velocity
Time
Move_trigger( 0x3 );
Axis0: WAIT
Time
Axis 0
Axis 1
ptp( axis0, MF_WAIT…);
ptp( axis1, MF_WAIT…);
Axis1: WAIT