3 drying cartridge (adsorption filter) – Martin Christ Epsilon 2-10D LSCplus User Manual
Page 35
Freeze-dryer EPSILON 2-10D LSCplus
5 Set-up and connection
Version 04/2013, Rev. 1.5 of 16/12/2014 • sb
35
Translation of the original operating manual
Pos: 100 /20 0 Ch rist/3 61 G T-BA L abo r-Pilot (PROJEKTE)/Epsilo n Sta nda rd/0 50 Aufs tellun g u nd Ansc hluss/0 50- 003 0 Tro ckne rpat ron e (Ad sor ptionsfilt er ) - Ü bersc hrift -- --- -- --- --- -- --- -- --- -- --- - @ 26\m od_ 140 505 799 428 5_68 .docx @ 1 909 60 @ 2 @ 1
5.3 Drying cartridge (adsorption filter)
Pos: 101 /20 0 Ch rist/3 61 G T-BA L abo r-Pilot (PROJEKTE)/Epsilo n Sta nda rd/0 50 Aufs tellun g u nd Ansc hluss/0 50- 003 1 Tro ckne rpat ron e Epsilo n (Ve ntil + Falt enb alg) - T ext @ 25\ mod _14 049 846 246 44_6 8.d ocx @ 185 679 @ @ 1
The drying cartridge prevents the air humidity from being absorbed by the
heat transfer medium.
During the transport of the freeze-dryer, the drying cartridge at the filler
neck of the heat transfer medium is removed from the filler neck of the heat
transfer medium. Prior to commissioning the unit, it must be installed.
• Remove the sealing cap (1) from the valve.
• Connect the supplied adapter (5) together with the drying cartridge (4)
to the valve (2).
• Open the valve (2) by turning it anti-clockwise up to the stop.
1 Sealing cap
2 Valve
3 Connection of the
expansion vessel
(inside the unit)
Fig. 16: Valve with sealing cap for transport
4 Drying cartridge
(adsorption filter)
5 Adapter
Fig. 17: Valve with drying cartridge (adsorption filter)
Special equipment: Stainless steel bellow at the hydraulic cylinder
If the freeze-dryer is equipped with a stainless steel bellow, a second drying
cartridge is located under the drying chamber (see chapter 2.1.1 - ""). This
drying cartridge is not removed during the transport.
NOTE
The silica gel of the drying cartridges has a limited adsorption capacity.
If the colour of the silica gel changes from orange to green (see label on
the drying cartridge), the drying cartridge must be replaced (Christ order
no. 610 990).