Martin Christ Epsilon 2-10D LSCplus User Manual
Page 53
Freeze-dryer EPSILON 2-10D LSCplus
6 Operation
Version 04/2013, Rev. 1.5 of 16/12/2014 • sb
53
Translation of the original operating manual
Pos: 144 /20 0 Ch rist/3 60 G T-BA L abo r-Pilot (STANDARDMODU LE)/0 60 Bet rieb/ LSCplus/ 060 -00 50- 001 0-0 021 Hau ptfe nster Prog ra mm Epsil on @ 25\ mod _14 049 839 6583 4_6 8.d ocx @ 183 788 @ 4 @ 1
6.5.1.2 Main window "Program"
In the main window "Program", pre-programmed freeze-drying processes
can be loaded and edited and new programs can be created with the
PGMplus programmer module.
1
Program list
2
Button "New
program"
3
Buttons "Load"
Fig. 35: Overview of the main window "Program"
Program list (1)
After the selection of the main window "Program", an overview of the
programs that have already been saved will be displayed. Pressing the
button "Load" (3) behind the program name calls up the program data.
Programs can be loaded, edited, copied, or deleted (see chapter 6.5.3 -
"Freeze-drying with the PGMplus programmer module").
"Dialog box "New program (2)
In this dialog box, new programs can be created either based on an already
existing program or completely from scratch (see chapter 6.5.3.1 -
"Creating a program").
Pos: 145 /01 0 Univ ersal mod ule/Seit enwec hsel @ 0\m od_ 120 211 624 4312 _0. docx @ 10 5 @ @ 1