Martin Christ Epsilon 2-10D LSCplus - Manual (Page 95)

Freeze-dryer EPSILON 2-10D LSCplus
8 Maintenance and service
Version 04/2013, Rev. 1.5 of 16/12/2014 • sb
95
Translation of the original operating manual
Pos: 206 /20 0 Ch rist/3 60 G T-BA L abo r-Pilot (STANDARDMODU LE)/0 80 Wa rtun g u nd In stan dhalt ung/ 080 -00 10- 001 0-0 010 Eiskon dens ato rkam me r (a uß er Epsil on 2 -4) @ 2 5\m od_ 1404 984 098 898 _68. docx @ 18 434 9 @ 4 @ 1
8.1.1.1 Ice condenser chamber
Before each start-up, ensure that the ice condenser chamber is free from
water residues.
• Open the media drain valve to drain off any liquid. Then, close the
valve.
• If necessary, wipe the ice condenser chamber dry with a cloth.
Pos: 207 /01 0 Univ ersal mod ule/L eerz eile @ 0\m od_ 120 211 624 450 0_0. docx @ 11 4 @ @ 1
Pos: 208 /20 0 Ch rist/3 61 G T-BA L abo r-Pilot (PROJEKTE)/Epsilo n Sta nda rd/0 80 Wa rtu ng u nd I nstan dhal tung /08 0-0 010 -00 10- 002 1 Son der ausst attu ng: Tüv erschl ussrie gel aus Edels tahl Epsilon @ 25 \mo d_1 404 9846 771 36_ 68.d ocx @ 185 889 @ 4 @ 1
8.1.1.2 Special equipment: Stainless steel door latch at the loading door
Systems that are equipped with a stainless-steel or acrylic glass door with a
stainless-steel door latch have a slide pad on the door latch. This slide pad
is included in the scope of supply as a spare part. It must be inspected
regularly for signs of wear. When its thickness is < 0.5 mm, it must be
replaced.
1
Door latch
2 Slide pad
(part no. 177270)
3 Torx screws
Fig. 79: Door latch and slide pad
Replacing the slide pad:
Unscrew the two screws of the slide pad with a Torx
® TX10 screwdriver,
remove the old slide pad, and install the new one.
Pos: 209 /01 0 Univ ersal mod ule/Seit enwec hsel @ 0\m od_ 120 211 624 4312 _0. docx @ 10 5 @ @ 1