Pitney Bowes DI425 FastPac Inserting Systems - Manual (Page 26)

2 • Operation
2-10 SV61656 Rev. A
Choosing the New Job Number
The machine asks for the job
number you wish the new settings
to be stored under.
Use the
Change (+/-) buttons to
display the job number you want.
Notes:
• If you use an existing job
number, the old settings will be overwritten by the new settings
you are about to make.
• If you want to find a currently unused job number, press Change
( +/-) until you see a job where the display shows no symbols
alongside the feeders or in the fold setup area. This means the
job number is currently unused.
Press Next (►) to advance to the next setting…
OMR
On models equipped with OMR ONLY, the machine will ask you to
select the OMR mode. For a non-OMR job, use Change (+/-) to se-
lect OMR off (if you wish to program an OMR job, see page 3-10).
Press
Next (►) to advance to the next setting…