Pitney Bowes DI425 FastPac Inserting Systems - Manual (Page 55)

OMR • 3
3-17 SV61656 Rev.A
Fold a sheet of material in half and measure the distance from the
side of the form to the middle as shown.
For an A4 size form, this
measurement is 105mm.
For a letter-size sheet (8.5
x 11 inches), it is 108mm.
Now measure the distance
from the edge of the form
to the middle of the scan
dash marks, as shown.
Then subtract this mea-
surement from the half-fold
measurement.
Example:
For an A4 size form, the
half fold measurement is
105mm.
If the distance from the
edge of the form to the
middle of the scan dash
marks is 10mm, the scan-
ning head setting will be
95mm (105mm minus
10mm).
Loosen the knurled locking knob and set the relevant scanning head
to the correct setting.
Retighten the locking knob.
If you’ve adjusted the bottom sheet feeder scanner, install both sheet
feeder 2 and the fold plate located below sheet feeder 2.
105mm
10mm
10mm
Locking knob