Pitney Bowes DI425 FastPac Inserting Systems - Manual (Page 69)

Reference • 4
4-11 SV61656 Rev. A
Message Action
CLOSE MAN ADV
COVER
The manual advance knob door is not fully
closed. Close door.
DEFLECTOR
ERROR
The half fold function is not possible due to a
fault. Remove fold plates and check for any
material.
DOUBLE FEED A double feed was detected from the feed
tray indicated. Remove the material from the
machine and restart. If double feeds persist,
request another trial piece.
DOUBLE FEED
CHECK STACKER
A double feed was detected from the feed tray
indicated. Remove the double feed from the
stacker. Restart machine.
FOLD PLATES
NOT SET
The fold plates are not set to the correct posi-
tion. Remove fold plates and check for any
material. Install fold plates and restart.
MANUAL FEED
TIMEOUT
Material was not detected as being fed from
the feeder within a set time. In manual feed
mode, you must feed the material within a set
time. Press Start to restart the machine.
PAPER SHORT The inserter detected that the material is too
short in length. Check that actual material
length matches the length displayed. If cor-
rect, request another trial piece.
PAPER SHORT
CHECK STACKER
The inserter detected that the material used is
too short in length. Check that actual material
length matches the length displayed. If cor-
rect, request another trial piece.
SET LEVER Manual feed lever in the incorrect position for
the mode you’re running. Move the manual
feed lever to the correct position (left position:
manual; right: automatic).
STREAM FEED The machine detected two sheets fed to-
gether from the feed tray indicated. Remove
material from the machine, reload and restart
machine.