Pitney Bowes DI425 FastPac Inserting Systems - Manual (Page 68)

4 • Reference
4-10 SV61656 Rev. A
Message Action
CALL SERVICE Power machine off and on. If message still
displays, call for service.
CHECK /CLEAR
FEEDER
The feeder indicated has failed to feed materi-
al. Remove material from the feed tray, reload
and restart machine.
CHECK FEEDER The feeder indicated is not located correctly.
Remove tray and relocate. Also check loading
of material in indicated feeder.
CHECK FOLD
PLATE
Fold plate indicated is not located correctly.
Remove fold plate and relocate.
CHECK
INVERTER
Envelope inverter unit has not set to its cor-
rect position. Open inverter cover and check
for any material. Close cover and restart.
CHECK LAST
MAIL PIECE
Envelope has failed to open. Check that en-
velopes are loaded correctly. Reload enve-
lopes and restart machine.
CLEAR FOLD
PLATE
Material was detected inside the fold plate in-
dicated on the display. Remove fold plate and
check for any material. Install fold plate.
CLEAR
INSERTION AREA
Material was detected in the inserting area.
Open tinted plastic cover on left hand side
of machine and remove any material. Close
cover and restart.
CLEAR
MOISTENER
Material was detected in the sealer brush
area. Open tinted plastic cover on left hand
side of machine and remove any material.
Close cover and restart.
CLEAR SEALER Material was detected in the sealer brush
area. Open tinted plastic cover on left hand
side of machine and remove any material.
Close cover and restart.
CLOSE COVER Cover indicated is not fully closed. Close indi-
cated cover and restart.
Error Messages