Pitney Bowes DI425 FastPac Inserting Systems - Manual (Page 87)

Appendix A —Glossary
SV61656 Rev. A A-9
Term Definitions
Power-On Reset Re-initializing a device by turning the power off,
then on.
Run A single instance of a job.
Scan Window A designated area on a sheet or insert reserved
solely for OMR marks. Sometimes referred to as
the “scan zone.” The start scan mark is located in
this zone and begins the scanning process. There
must be no printed material in the scan window
other than the OMR marks.
Scanner A device that reads OMR dash marks.
Sealer A module in an inserting system that moistens an
envelope flap, closes and seals it.
Sealing The process of moistening an envelope flap, clos-
ing it and applying pressure to seal it.
Select With respect to the operator interface (control
panel), the process of making a choice.
Select Feed Marks Marks on the prime or control document (or first
sheet in the control document) that indicate which
downstream feeders should feed. A downstream
selectable feeder will feed if the mark is present
on all pages of the control document.
Selective feed A function that instructs the inserter system to
select material from specified feeders. This is
controlled by select feed OMR marks.
Set One or more items assembled together.
Sheet A paper item, folded or unfolded, taken from a
stack of material.
Sheet Feeder A feeder tray that accepts sheets only. The
sheets are loaded one on top of another.
Sheet Set A collection of sheets or pages, usually defined
by the user. A sheet set is made up of sheets only
(inserts are not sheets).
Shingle To align sheets or inserts such that they overlap,
but are not directly above one another (like shin-
gles on a roof). Shingling is required for reliable
feeding of some material types.
Single sheet One sheet of paper.