Pitney Bowes DI425 FastPac Inserting Systems - Manual (Page 38)

2 • Operation
2-22 SV61656 Rev. A
Changing an Existing Job
To change an existing job:
1. Enter the setup mode as described on page 2-9.
2. Use the
Change (+/-) buttons to display the job you wish to edit.
3. Use the Prev (◄) and Next (►) buttons to display the setting(s)
you wish to change.
4. Use the Change (+/-) buttons to change the options/dimensions
you wish to amend.
5. Press the Setup button to leave the setup mode and save the
changes.
Deleting a Job
To erase an existing job from memory:
1. Enter the setup mode as described on page 2-9.
2. Use the
Change (+/-) buttons to display the job you wish to de-
lete.
3. Press the Delete button. The display reads “Press again to con-
firm”. Press Delete again. The display will briefly read ‘Deleting
Job’ as the job is erased.
4. Press the Setup button to leave setup mode.