Altera Nios Development Board - Manual (Page 50)

B–2 Altera Corporation
July 2005
Reprogramming the EPM7128AE Configuration Controller Device
3. Click Add File and select the following programming file:
<Nios II kit path>/examples/
factory_recovery/niosII_stratixII_2s60_ES/config_controller.pof
.
4. In the Programmer, check the Program/Configure box, and click
Start
to reprogram the EPM7128AE device.
5. Press the Factory Config button to perform a power-on reset and
reconfigure the Stratix II device from flash memory. You should see
the Factory LED turned on and activity on LEDs D0 through D7.
Your board is now reconfigured to the default factory condition.