Monroe Electronics Electrostatic Fieldmeter - Static Monitor - model 177A - Manual (Page 91)

APNE-0016 90
number is 1036/12-nnnn, where nnnn denotes the length of the cable in feet. Factory
supplied extension cables will be labeled with this part number near one end. The
cables need to be long enough to reach from the console location, through the
conduit, and to the probe location with a few feet extra for measurement error.
Remove and discard the factory supplied (usually ten-foot) cable from the probe
(Model 1036E only), and mount the probe housing at the measurement location.
Cut the female DB9 connector plug off the extension cable.
Pull the cable from the IS Barrier and/or Model 177 instrument end of the conduit to
the probe end.
2. Buy bulk cable and connect both ends manually.
Cable construction details for 1036E probes with customer installed cables are
provided in Figure V-1. This option does not apply to 1036F probes, which have
permanently attached cables.