Tag cut dimensions – Avery Dennison Monarch 9855 Operator Handbook User Manual
Page 116
A-2 Operator's Handbook
Printing Method:
Thermal Transfer (ribbon) or Thermal Direct
Print Speed:
2.5 ips (64 mm) default for all serial bar codes, 4.0 ips
(102 mm), 6.0 ips (152 mm) default for parallel bar
codes, 8.0 ips (203 mm), and 10.0 ips (254 mm). 12.0
ips (305 mm) printing is an option that must be
purchased separately.
See Chapter 8, "Printing" for special considerations
when printing at speeds greater than 6.0 ips.
Maximum Print
4.0 inches x 16.0 inches (102 mm x 406 mm)
Area:
with 203 dpi
4.0 inches x 13.0 inches (102 mm x 330 mm)
with 300 dpi
Tag Cut Dimensions
Use these specifications for the 926™ Knife.
Widths:
0.75 inches to 4.0 inches (19 mm to 102 mm)
Lengths:
1.2 inches to 16.0 inches (30 mm to 406 mm)
Note:
The maximum cut tag length using the
stacker is 3.66 inches (93 mm).
Thickness:
7 mils to 10 mils
Cut Angle:
5 degrees (plus or minus) from 90 degrees with
respect to the edge.
Batch Separator:
3.66 inches (93 mm)