Avery Dennison Monarch 9855 Operator Handbook - Manual (Page 30)

3-2 Operator's Handbook
L o ad i n g Ri b b o n
Make sure the printer is configured to use a ribbon.
To load ribbon:
1. Open the cover.
2. Unlock the printhead by turning the retaining latch.
3. Lift printhead assembly using the printhead tab until the assembly locks
into place.
4. Push the deflector tab down.
5. Slide the extra ribbon core on the take-up reel as far as it will go with the
"This End Out" writing facing out. Use your empty ribbon core as the
take-up core. The take-up core only fits on the take-up reel one way.
(An extra take-up core is available by ordering part number 117961.)
P ri nthead
As sem bl y
Defl e ctor
Tab