Setting the backfeed distance, Setting the backfeed distance -14 – Avery Dennison Monarch 9855 Operator Handbook User Manual
Page 48
4-14 Operator's Handbook
Setting the Back feed Dis tance
This is the amount to move the label backwards. The backfeed distance
cannot be greater than the dispense position. If you make the backfeed
distance greater than the dispense position, the dispense position
automatically changes to match the backfeed distance.
The backfeed distance should equal the dispense position. An exception is
when you are tearing labels, instead of peeling. Then, the backfeed distance
must be 30 dots (0.15 inches) less than the dispense position to account for
improper tearing of butt cut supplies. You will have a 30-dot non-print zone
on your supply, but this prevents exposed adhesive under the printhead.
To change the setting, from the Main Menu, select Setup, Supply, then
Positioning. Follow these steps.
1. Press or until you see
POSITIONING
Backfeed Dis
2. Press Enter/Pause.
BACKFEED DIS
[10/200]: +65
3. Press or to change the dispense position. Pressing decreases
the value;
increases it.
4. Press Enter/Pause when the number you need appears.
Press Escape/Clear until you see the Main menu.