Avery Dennison Monarch 9855 Operator Handbook - Manual (Page 17)

Loading Supplies 2-1
L O A D I N G S U P P L I E S
This chapter describes how to load:
♦ a roll of supply
♦ fan-fold supply
♦ a roll of tag supply.
There are three types of supplies:
Thermal Direct heat activated supplies that do not use a ribbon for
printing.
Thermal Transfer standard supplies that require a ribbon for printing.
High Energy scratch, chemical, and temperature resistant supplies
that require an elevated heat setting for resin ribbon
applications. See "Using a High Energy Ribbon" in
Chapter 3 for more information.
If you are using thermal direct supplies, do not load a ribbon.
If you switch from black mark to die cut supplies, make sure the printer's
supply type is set correctly. See "Supply Type" in Chapter 4 for more
information. Your System Administrator can also send the supply setup
packet to change the supply type. Refer to the optional Packet Reference
Manual for more information about sending the supply setup packet.
2