Avery Dennison Monarch 9855 Operator Handbook User Manual
Page 98
9-2 Operator's Handbook
You may need to clean the printhead, sensor, and platen roller:
♦
if there is any adhesive build-up in the supply path.
♦
after printing approximately 3 rolls of thermal
transfer/thermal direct supplies or
after each ribbon.
♦
daily if your printer is in an excessively dirty,
hot, or humid environment.
♦
when you see voids or streaking in the print
as shown.
When you are using higher speeds (with 203 or
300 dpi), and/or increased print contrast, we
recommend cleaning the printhead after each
ribbon with isopropyl alcohol. If you still notice
build-up on the printhead or black streaks on
your supply, order a printhead CLEAN-STRIP.
1. Turn off the printer and open the cover and printhead assembly.
2. Remove the label roll and ribbon (when cleaning the printhead).
3. Press down on the exit cover tabs to open the exit cover on the front of
the printer.
V oi ds
S treak s
E xi t Cover